Features listed:
Main section: - Dry/wet control with FX bypass button - Preset patches section - Reset (audio reset) - Uses sound banks (folders) composed of 128 patches

Distortion: - Tube saturation distortion - Amount control - On/off

Ensemble: - Multi voice chorus - Amount control - Routing into the reverb or direct + reverb - Volume control - On/off

Early Reflections: - Complex Early reflection algorithm - Routing into reverb or direct - Lenght / damping / feedback / side-feedback / cross-feedback control - on/off

Reverb: - RPCX Algorithm reverb - Space types: Hall clean, Hall cave, Hall swirl, Hall wild 1, Hall wild 2, -Room cold, Room edged 1, Room edged 2, Room storm 1, Room storm 2, Room storm 3, Space orbit 1, Space orbit 2, Space orbit 3 and Space orbit 4. - Space color types: Clean, Multi 1, Multi 2, Multi 3, and Swirl - Size control with disorder control / Length control - Pre-delay with disorder control - Diffusion control - Damping control - Low-pass and hi-pass filters - Volume control - On/off

Late reflection: - Late reflection delay - Routing into reverb or direct - Length control and damping control - Volume control - On/off

EQ: - High-quality EQ with "post" setting option - Low at 10Hz / Mid at 4kHz / High at 8kHz

Envelope: - Special Envelope for 'Gated Reverb' effect, 'Non-Linear Reverb' effect or 'Special Reverb' control - Control options: audio / space size / reverb length / size + length / size + lenght + audio - Amount control for space size / reverb lenght - Mono input option - Latch mode option - On/off

Back panel: - Stereo input/output - HQ Mode on/off - CV input for parameter control: Wet/Dry, Ensemble volume, Distortion amount, Early reflection volume, Late reflection volume, Reverb space size, Reverb length, Reverb diffusion, Reverb damping and Envelope trigger. - L / R Sidechain input for envelope

You need R2R's Reason release and TEAM R2R Reason Rack Extension Cache Builder

Copy the RackExtension folder to
"%APPDATA%\Propellerhead Software\RackExtensions\"

Copy *.R2RRECACHE file to
"%APPDATA%\Propellerhead Software\R2RRECACHE\"

After you add new RackExtension(s), you need to rebuild the RE cache:
- Just run "RECacheBuilder.exe" from TEAM R2R Reason Rack Extension Cache Builder
- Cache file will be built.
- Done!

Big thanks to R2R for sharing their knowledge and providing the resources!

Whats new in this version:
Official site does not provide any info about changes in this version.

System Requirements
Windows: Windows 7 or higher

HOMEPAGE

https://www.reasonstudios.com/shop/rack-extension/rpverb-effect/